My Land Cruiser has been having problems with the 4L setting... I think

[YerAWizardHarry]

Is there just something wrong with me or is it with the vehicle because I just used the 4WD low setting (I've been using it for a while now) again after like a week or something and it's beeping? It didn't stop at all and the noise was nauseating!!! Lol is it a me problem or what. I shifted to neutral before anything else btw so it could not have been that.

 

[HappyHunter95]

No need to panic lol, just shift it to neutral and engage 4 low

 

[MadScientiest13]

Should be normal bro, it warns if somethings off or the mode's active too long. And since you shifted to neutral, it's probably the system, not you.

 

[thegentleman]

Even if you did everything right, it could be a sensor glitch or a transfer case issue, so thats not your fault. Try cycling back to 2WD, drive a bit, then switch again. If it still beeps, time to get it checked out by an expert one

 

[fuel6uzzler]

That stinks, but don't sweat it too much. It could just be a quirky sensor or something with the transfer case. Try this: pop it back into 2WD, drive around a little, then try the 4WD low again. If that beeping won't quit, you should probably let a mechanic take a look

 

[lemony snickets]

That happened to me once!!! Apparently, the shift motor was sticking. I guess the better thing to do here is to cycle between 4H and 4L a few times.